Hontko HLS-S-10-1A-P Linear wire encoder

HLS-S series is an incremental wire-drawn encoder suitable for measuring shorter strokes

Measurement stroke: 1000mm

Resolution: 1/0.1/0.04 mm/pulse

Output signal form: ABZ three-phase

Maximum response frequency: 100kHz

Maximum round-trip speed: 1000mm/s

Output form: push-pull output, line drive output

Output voltage: DC 5-26V

Protection level: IP50

Ambient temperature: 0 ~ +60℃

Specifications

Measuring Range: 1000 mm

Resolution: 1 / 0.5 / 0.2 / 0.1 / 0.04 mm /pulse

Features

Suitable for short measurement range.

ELECTRICAL SPEC.

Detection System: Incremental 

Output Wave: Square Wave 

Stroke (mm): 1000

Standard Resolution (mm/pulse):  1, 0.5, 0.2, 0.1, 0.04 mm/pulse 

Repeatability Error:  ±0.05% FS, ±1 count

Output Phase: ABZ phase

Electronics Push: Pull or Line Driver

Power Supply: DC 5~26V

Current Consumption: ≤ 60 mA

Output Capacity: Sync. Current: 20 mA, Residual Voltage: 0.5V or less

Max. Response: Max. 100K Hz

Phase Different: A, B phase different 90°±45° (T/4±T/8), Z phase T±T/2 Wave Form Rise / Fall 波形上下時間 2 μs or less

Polarity: Against Reverse Protection

MECHANICAL SPEC.

Wire Specification: Material: SUS304 with nylon coating Diameter: 0.6 mm; Breaking load: 16 Kg

Max. Travel Speed: 1,000 mm / sec.

Vibration: Max. 10g (10 ~55 Hz / 1.5 mm X.Y.X. 2Hr)

Shock: 20g per 11 ms

Cable: Ø4.5, 50 cm long

Weight: < 450g

Starting Torque on Spring 拉力 Max. 700 g

ENVIRONMENTAL SPEC.

Operating Temp. / Humidity: 0°C ~ 60°C, RH 35% ~ 90% (No Condensation) Storage Temp.: -20°C ~ 70°C

Protection: IP50: Dust Proof (only for encoder housing)

Life: Typical > 1 X 106 cycles